Gaskets |
How to Measure a Gasket Frame
All standard gasket frame dimensions should be measured edge to edge even if the gasket has snap-in darts.
Note: This is not the case when measuring for custom-made gasket frames. When ordering custom-made screw-in style frames, the dimensions should be measured edge to
edge. When ordering custom-made snap-in style frames, the dimensions should be measured dart to dart.
|
Pre-Installation Tips
- Allow replacement gasket to reach room temperature before unfolding.
- Carry gasket by its corners and avoid squeezing folds to prevent breaking the internal magnetic strip.
- Thoroughly clean the area of the door where the gasket attaches, and the cabinet perimeter that the gasket face contacts.
|
Distortions
Our gaskets are made from a vinyl material which can become distorted from folding. The folding is necessary to allow a practical and economically sized shipping parcel.
The vinyl material retains a "memory" of its original shape so any distortions or kinks will only be temporary.
Return to the original shape can be greatly accelerated by the application of heat, for example:
- Immerse gasket in 140-185°F water for 15 to 30 minutes before installing.
- Apply heat from an electric hair dryer or heat lamp before and after installation. Care must be taken not to overheat which could stretch or melt the material.
|
Magnetic Seal
Magnetic gaskets usually will not form a strong seal when first installed, they normally require a few weeks to totally develop their maximum contact and strength.
|
Field Repairs
If the vinyl material is accidentally torn or damaged, it can usually be adequately repaired by welding with a soldering iron or gluing with a vinyl adhesive.
|
